1. Red Light Flashing (Cat Sensor Fault) - Litter-Robot 3
If the cat does not exit the robot, or if the cat sensor continues to detect weight for up to 30 minutes, the robot will display a flashing red light indicating ...
Learn how to troubleshoot and fix the cat sensor fault on your Litter-Robot 3. Follow step-by-step instructions to address red light flashing issues and ensure the proper functioning of the cat sensor.
2. Litter-Robot 4: Red light bar flashing (Cat sensor fault)
If your unit has a flashing red light bar or the unit will not cycle, this indicates that the cat sensor has been triggered for more than 30 minutes.
Troubleshooting a flashing red light on your Litter-Robot 4? Visit our support page for effective solutions to cat sensor faults. Get help now!
3. Litter robot III red light flashing - RobotShop Community
Meer resultaten van community.robotshop.com
I purchased a new cat sensor and installed it but still didn’t fix the problem. I’ve unplugged it, turned off and on but it still is flashing red and globe won’t turn. Any suggestions?
4. Litter-Robot 4: Red light bar with partial white flashing (Globe position)
If your unit displays a red light bar with partial white flashing, this indicates that the unit did not detect the globe position during its previous cycle.
Visit for solutions if your Litter-Robot 4 has a red light bar with a partial white flashing globe. Get instant support and fixes today.
5. Litter-Robot 4: Light codes guide
If your unit's light bar is flashing red, this indicates that a cat (or weight) has been detected for over 30 minutes. Learn more. Red momentary flash. If your ...
See AlsoLa Casa 168Th And Pacific MenuDiscover solutions for all Litter-Robot 4 light codes in our comprehensive guide. Find quick fixes and get your Litter-Robot working perfectly again. Click now!
6. Red & Blue Alternating Light Bar Issue - Litter-Robot 4
Litter-Robot 4: Red and blue alternating light bar (OmniSense laser sensor fault) · Make sure your unit is plugged in. · Make sure your unit is connected and ...
Encounter a Laser Board Fault in your Litter-Robot 4? Navigate to our site for expert solutions on fixing red-blue-alternating-light-bar issues.
7. Green with Partial Red Flashing - Litter-Robot 4
If you see a green ping-pong sequence on the light bar, it means the three curtain sensors are attempting to auto-calibrate their cat detection levels. This ...
Learn to troubleshoot, clean, and calibrate OmniSense Sensors for peak Litter-Robot performance. View our troublshooting guide for help now!
8. Litter-Robot 3: All three lights flashing (Globe position fault)
Blue and yellow and red (All three lights flashing simultaneously): This means the unit cannot find the Dump or Home position. The unit will not cycle ...
Find solutions for your Litter-Robot 3's three lights flashing position sensors issue. Fix issues with your Connect Upgrade Kit today!
